Bosch Washing Machine Spares & Replacement Parts
Identify and source genuine Bosch OEM replacement parts for Serie 2, Serie 4, Serie 6, Serie 8, and Logixx front-loading washing machines using your exact E-Nr model code.
Where to Find Your Model or Part Number
To guarantee 100% compatibility, check these standard locations for model badges, OEM stampings, and serial numbers:
- E-Nr (Model) & FD (Production) Plate: On the inside rim of the door or behind the lower circular pump access flap
- Bosch Part Numbers: Stamped in 8-digit format (e.g. 00145787, 00361127)
Frequently Replaced Components & Spares
Bosch Magnetic Drain Pumps
Original magnetic synchronous drain pump assemblies (00145787 / 00144978)
Moulded Rubber Door Seal Gaskets
Silicone and rubber door bellows with drainage ports and inner retaining springs
Wash Heating Elements & NTC Sensors
2000W / 2050W heating elements with integrated thermal fuses and NTC pockets
EcoSilence Drive Inverters & Brushes
Standard carbon brushes (for brushed models) and electronic motor inverters
Common Symptoms & Fault Diagnostics
| Observed Symptom | Likely Root Cause | Recommended Action |
|---|---|---|
| E18 error code on Bosch washing machine display | Drain pump blocked with lint, coin, or hairpin; or pump impeller motor failed | Unscrew lower drain filter into a shallow tray to clear obstruction |
| Water leaks from under the door during wash cycle | Torn, punctured, or mould-rotted rubber door seal bellows | Inspect seal perimeter for tears, especially at 6 o'clock drainage point |
| E23 error code (AquaStop activated) | Water detected in the base plate trigger sponge from an internal hose leak | Inspect and replace faulty component. |
Compatibility Verification Checklist
Before ordering replacement components, verify these technical specifications to avoid returns:
How to Photograph Your Part for AI Identification
- 1Take a clear photo of the rating plate sticker located inside the door frame or filter flap
- 2For door seals, photograph any part numbers molded into the rubber lip
Safety & Legal Compliance Notice
Always isolate the machine from 230V mains electricity and turn off water isolation valves before servicing internal components.